Asus TX97-L TX97-L User Manual - Page 29
ASUS TX97-L User's Manual, ATX Power Supply Connector ATXPWR, 20-pin block, AT Power Supply
View all Asus TX97-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
III. INSTALLATION 9. ATX Power Supply Connector (ATXPWR, 20-pin block) This connector connects to a ATX power supply. The plug from the power supply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned. IMPORTANT: Make sure that your ATX power supply can supply at least 10mAmp on the 5-volt standby lead (5VSB). You may experience difficulty in powering on your system if your power supply cannot support the load. For Wake on LAN support, your ATX power supply must supply at least 720mAmp. III. INSTALLATION (Connectors) Thermal Sensor R ATX Power Connector +3.3 Volts -12.0 Volts Ground Power Supply On Ground Ground Ground -5.0 Volts +5.0 Volts +5.0 Volts +3.3 Volts +3.3 Volts Ground +5.0 Volts Ground +5.0 Volts Ground Power Good +5V Standby +12.0 Volts 10. AT Power Supply Connector (POWER, 12-pin block) This connector connects to a standard 5 Volt power supply. To connect the leads from the power supply, ensure first that the power supply is not plugged. Most power supplies provide two plugs (P8 and P9), each containing six wires, two of which are black. Orient the connectors so that the black wires are together. Thermal Sensor R AT Power Connector +5V -5V GND +12V PG -12V +5V Power Connector on Motherboard RED RED RED P9 WHT BLK BLK BLK BLK BLU YLW P8 RED ORG Power Plugs from Power Supply Using a slight angle, align the plastic guide pins on the lead to their receptacles on the connector. Once aligned, press the lead onto the connector until the lead locks into place. ASUS TX97-L User's Manual 29