Asus Z94G Z94 Hardware User's Manual for English Edition (E2219) - Page 43

4 Using the Notebook PC Modem Connection The telephone wire used to connect the Notebook PC's internal modem should have either two or four wires (only two wires (telephone line #1) is used by the modem) and should have an RJ-11 connector on both ends. Connect one end to the modem port and the other end to an analog telephone wall socket (the ones found in residential buildings). Once the driver is setup, the modem is ready to use. NOTE: When you are connected to an online service, do not place the Notebook PC in suspend (or sleep mode) or else you will disconnect the modem connection. WARNING! Only use analog telephone outlets. The built-in modem does not support the voltage used in digital phone systems. Do not connect the RJ-11 to digital phone systems found in many commercial buildings or else damage will occur! CAUTION: For electrical safety concerns, only use telephone cables rated 26AWG or higher. (see Glossary for more information) Example of the Notebook PC connected to a telephone jack for use with the built-in modem: Telephone cables with RJ-11 connectors Telephone connector is the smaller of the two. Telephone Wall Jack Telephone connection is optional 43