Audiovox VOH682A Installation Guide - Page 9
VOH682A - headphones
UPC - 044476742057
View all Audiovox VOH682A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
VOH682A Note: cables exiting the pod should be routed as shown. TO FACTORY RADIO Red: +12 VDC (Accessory Cir.) Black: Ground Power Harness Item #4 3a choke Optional Hard Wired FM Modulator Output 12 VDC Power and Ground Left Am/Fm Input Antenna FM Modulator Dash Radio 1070610 *Refer to Instructions with the RF Right Input Modulator Kit for further details. RCA-Female Patch Cord RCA-Female To Secondary AV Monitor Wireless FM Modulator Antenna LEFT WHITE RIGHT RED Mini-Din Connectors 21 TV antenna (If applicable) TO OPTIONAL ADDITIONAL MOINTOR 12 VDC Power and Ground Auxillary video display INPUT VIDEO RCA-Female Patch Cord RCA Male to Male LINE OUT VIDEO Accessory Harness Item#22 Accessory Harness Item#21 Red RCA (Audio Right) White RCA (Audio Left) Yellow RCA (Video) Optional External Speakers Green (Right+) Black (Ground) Gray (Left+) IR LED: Clean the IR Receiver Window on the front of the VCP. Remove Adhesive Backing and Apply IR LED to IR Window on the Face of the VCP. "Y" Adapter for use with Non-Stereo Installations Item#5 3b 1) Make the connections to the vehicle for the 12 pin wiring harness. 2) Remove screws on PCB Cover. Open the cover to gain access to Mini-Din Connector on main PCB. (Cover will remain attached at to rivet hole). 3) Insert the Circular Mini-Din Connector of the source Component Harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB. 4) Pull the wire tie loop tight and cut off the excess. 5) Connect the Power Harness to the mating connector on the Video Monitor. 6) Connect the wired RF Modulator and / or the remote headphone jacks to the video monitor if those options are being included. 7) Connect power harness to vehicle's electrical system by tapping into an accessory hot line. 8) Reinstall PCB cover using the 2 screws. 9) Connect and mount the Television antenna, or optional diversity antennas. 10) Verify all functions of the System before final mounting of the finished assembly. Note: A second VCP or other A/V Component can be connected to the video monitor system using a second Source Component Harness (purchased separately, part number: 8010730). This second harness would plug into the second Mini-Din connector on the main PCB as in steps 2 and 3 above. A/V Source Definitions: 1= VCP (right Mini Din on main PCB) 2= Tuner 3= 2nd VCP (or game or future DVD, etc..... left Mini Din) 4= Aux Input (RCA jacks on the face of the monitor). Note: Installation Guide covers models : VOH682A. -7-