Behringer 112 DUAL VCO Quick Start Guide
Behringer 112 DUAL VCO Manual
 |
View all Behringer 112 DUAL VCO manuals
Add to My Manuals
Save this manual to your list of manuals |
Behringer 112 DUAL VCO manual content summary:
- Behringer 112 DUAL VCO | Quick Start Guide - Page 1
Guide 112 DUAL VCO Legendary Analog Dual VCO Module for Eurorack Controls (1) (2) (9) WEAK/STRONG - Determines the accuracy of synchronization. (10) PITCH - Fine tunes the VCO. (4) PULSE WIDTH - Adjusts the pulse width modulation based on the voltage received at the PW MOD IN jack. (5) MOD MANUAL - - Behringer 112 DUAL VCO | Quick Start Guide - Page 2
Maximum input level VCO Output Type Impedance 100 kΩ, unbalanced 10 V p-p 2.5 V p-p 2 x 3.5 mm TS jacks, DC coupled 1 kΩ, unbalanced 10 V p-p Control Inputs Type Impedance CV range Controls PW level PW manual Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Auratone and Coolaudio are
-
1 -
2
 |
 |
Quick Start Guide
112 DUAL VCO
Legendary Analog Dual VCO
Module for Eurorack
Controls
(1)
PW MOD IN
– Accepts a voltage from another module to
control the pulse width.
(2)
VCO OUT
– Send the VCO signal to one or two sources via
3.5 mm TS cables.
(3)
WAVEFORM
– Select pulse, triangle or sawtooth
waveforms for the VCO.
(4)
PULSE WIDTH
– Adjusts the pulse width modulation
based on the voltage received at the PW MOD IN jack.
(5)
MOD MANUAL
– Sets the ratio between the upper and
lower portions of the pulse wave.
(6)
SYNC OUT
– Sends a synchronization signal via 3.5 mm
TS cable.
(7)
RANGE
– Sets the pitch range of the VCO in octave steps.
(8)
SYNC IN
– Accepts a synchronization signal via 3.5 mm
TS cable.
(9)
WEAK/STRONG
– Determines the accuracy
of synchronization.
(10)
PITCH
– Fine tunes the pitch.
(11)
MOD LEVEL
– Adjusts the level of the signal connected
to the associated MOD IN jack.
(12)
MOD IN
– Accepts voltages that control or modulate
the VCO pitch.
Power Connection
The module comes with the required power cable for connecting
to a standard Eurorack power supply system. Follow these
steps to connect power to the module. It is easier to make
these connections before the module has been mounted into
a rack case.
1.
Turn the power supply or rack case power off and
disconnect the power cable.
2.
Insert the 16-pin connector on the power cable into the
socket on the power supply or rack case. The connector has
a tab that will align with the gap in the socket, so it cannot
be inserted incorrectly. If the power supply does not have
a keyed socket, be sure to orient pin 1 (-12 V) with the red
stripe on the cable.
3.
Insert the 10-pin connector into the socket on the back of
the module. The connector has a tab that will align with the
socket for correct orientation.
4.
After both ends of the power cable have been securely
attached, you may mount the module in a case and turn on
the power supply.
(3)
(4)
(1)
(2)
(12)
(10)
(11)
(5)
(6)
(7)
(8)
(9)
V 1.0