Behringer HEAVY METAL HM300 Manual

Heavy Metal Distortion Effects Pedal

Thank you for showing your confidence in us by purchasing the BEHRINGER HEAVY METAL HM300.

This high-quality effects pedal enables you to produce super thick, tube-like distortion plus

endless sustain. Thanks to its high-performance features you can achieve the typical hard rock

or heavy metal distortion sounds.

1.

Controls

(1)

The

LEVEL

control adjusts the output level.

(2)

The

LOW

control allows you to boost/cut the low-frequency range.

(3)

The

MID

control allows you to boost/cut the mid-frequency range.

(4)

The

DIST

control adjusts the amount of distortion effect and the length of the resulting

sustain time. High distortion settings will cause longer sustain times.

(5)

The

ON/BATT

LED illuminates when the effect is activated. It also serves as a battery level indicator.

(6)

Use the footswitch to activate/deactivate the effect.

(7)

Use this ¼" TS

IN

connector to plug in the instrument cable.

(8)

The ¼" TS

OUT

connector sends the signal to your amp.

Use the

DC IN

connection to plug in a 9 V power supply (not included).

The

BATTERY COMPARTMENT

is located underneath the pedal cover. To install or replace the 9 V battery

(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to

scratch the unit.

◊

The HM300 has no on/off switch. As soon as you insert the plug into the in connector,

the HM300 is on. When not in use, remove the plug from the in connector. This extends

the life of the battery.

The

SERIAL NUMBER

is located at the underside.

(5)

(1)

(8)

(6)

(7)

(3)

(2)

(4)