Behringer HEAVY METAL HM300 Manual - Page 1

HEAVY METAL HM300 Heavy Metal Distortion Effects Pedal Thank you for showing your confidence in us by purchasing the BEHRINGER HEAVY METAL HM300. This high-quality effects pedal enables you to produce super thick, tube-like distortion plus endless sustain. Thanks to its high-performance features you can achieve the typical hard rock or heavy metal distortion sounds. 1. Controls (5) (1) (4) (2) (3) (8) (7) (6) (1) The LEVEL control adjusts the output level. (2) The LOW control allows you to boost/cut the low-frequency range. (3) The MID control allows you to boost/cut the mid-frequency range. (4) The DIST control adjusts the amount of distortion effect and the length of the resulting sustain time. High distortion settings will cause longer sustain times. (5) The ON/BATT LED illuminates when the effect is activated. It also serves as a battery level indicator. (6) Use the footswitch to activate/deactivate the effect. (7) Use this ¼" TS IN connector to plug in the instrument cable. (8) The ¼" TS OUT connector sends the signal to your amp. Use the DC IN connection to plug in a 9 V power supply (not included). The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to scratch the unit. ◊ The HM300 has no on/off switch. As soon as you insert the plug into the in connector, the HM300 is on. When not in use, remove the plug from the in connector. This extends the life of the battery. The SERIAL NUMBER is located at the underside.