Behringer SO400 Manual - Page 1
Behringer SO400 Manual
View all Behringer SO400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
SUPER OCTAVER SO400 Ultimate Octaver Effects Pedal Thank you for showing your confidence in us by purchasing the BEHRINGER SUPER OCTAVER SO400. This is the ultimate octaver with polyphonic input and the capability of creating octaves 1 and 2 octaves below the original tone. Take off with ultra-stable octaver sounds plus an aggressive Drive mode for fat overdrive sounds. 1. Controls (5) (1) The MODE switch selects one of the following operation modes: (2) (1) POLY: Single octave sound which allows to play treble tones (3) (4) without effect over bass tones with octave effect. (10) (7) OCT 2: Heavy octave sound, adds a second octave to the first one. DRIVE: Adds an overdrive effect to (8) (9) the original and the octaved signal. (2) The DIRECT control adjusts the level of the original input signal (and the DIR OUT connector). In DRIVE mode it adjusts total volume. (6) (3) The OCT 1 control adjusts the level of the generated signal one octave below the original signal. (4) The function of this knob depends on the position of the MODE switch (1): POLY>RANGE: Defines the frequency range in which the input signal triggers the octave effect. OCT 2>OCT 2: Controls the volume of the second octave. DRIVE>DRIVE: Controls the depth of the overdrive effect. (5) The blue ON/BATT LED illuminates when the effect is activated. It also serves as a battery level indicator. (6) Use the footswitch to activate/deactivate the effect. (7) The ¼" TS connector (GTR IN) is optimized for guitars. Use connector BASS IN (9) for optimized bass guitar performance. (8) The ¼" TS connector (OUT A) connects to your amp. (9) The ¼" TS connector (BASS IN) is optimized for bass guitars. Use connector GTR IN (7) for optimized guitar performance. (10) The ¼" TS connector (DIR OUT) passes the unaffected input signal through, as long as the effect is inactive. Thus OUT A is muted. When the effect is active, the effects signal is sent through OUT A while the DIR OUT carries the input signal. The volume of the DIR OUT signal is depending on the DIRECT control's setting. This output configuration is useful when different effects should be added to the input signal and the effect signal, after the octave pedal's output. ◊ If the DIR OUT connector is not in use, the unaffected input signal and the effect signal are both sent out through OUT A, depending on the effect activation. Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included). The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to scratch the unit.