Behringer ULTRA-DI DI100 Manual - Page 11
DI100 Configurations, 2.1 Tapping signal from the (Bass) guitar
View all Behringer ULTRA-DI DI100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
11 ULTRA-DI DI100 User Manual ◊ Only use the -20 dB switches if you are sure the ULTRA-DI is clipping (overloading) and not your mic pre-amp. Always use as little attenuation as possible to get the best possible signal-to-noise ratio. (6) OUTPUT. This is the balanced microphone level output of the ULTRA-DI. Connection to the microphone input should be made with a standard high quality balanced cable. ◊ Never connect pin 2 or 3 to pin 1 and never disconnect the shield from pin 1, or the unit will not work on phantom power. (7) Use the GROUND LIFT switch to either connect the ground of input and output or keep them completely separate. Depending on the grounding of the connected devices linking or disconnecting will reduce hum or prevent ground loops. GROUND LIFT ON means no interconnection. (8) BATTERY COMPARTMENT. Loosen the screw to open the compartment and to replace the 9 V battery. When the ULTRA-DI is switched on battery power the LED blinks, when it stops blinking it is time to change the battery. 2. DI100 Configurations The next section will show several different ways the ULTRA-DI can be hooked up. 2.1 Tapping signal from the (Bass) guitar Out In DI100 Microphone Input Link Out Fig 2.1: Guitar ➟ DI ➟ Guitar Amp/Mixerv