Behringer ULTRA-G GI100 Quick Start Guide - Page 16
ULTRA-G GI100 Controls - di manual
View all Behringer ULTRA-G GI100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
30 ULTRA-G GI100 ULTRA-G GI100 Controls (1) (2) (3) (4) (5) (6) (7) (8) 31 Quick Start Guide (EN) Controls (1) The VIRTUAL 4 x 12" CAB speaker simulation can be switched on and off with the SIMULATOR ON/OFF switch. (2) When activated, the GND LIFT breaks the ground connection between input and output. Depending on the grounding of the connected equipment, this can eliminate hum or ground loops. (3) OUTPUT TO MIXER is the GI100's balanced, mic level output. Use a high-quality, balanced XLR (microphone) cable to connect the ULTRA-G to a console. (4) BATTERY COMPARTMENT. To install or replace the 9 V battery, remove the screw and lift the lid. (5) The CLIP LED lights up when the input signal level is too high. (6) The two -20 dB PAD switches noticeably increase the operating range of the ULTRA-G, allowing it to accept anything from the low-level signal of a high-impedance microphone or guitar to the loudspeaker output of a guitar amp. These switches have repeatedly proven themselves in the BEHRINGER ULTRA-DI DI100. Pressing both switches results in a gain reduction of 40 dB. (7) INPUT. Use this 1/4" mono jack to connect the signal source, e.g. your guitar, with a high-quality standard instrument cable. (8) The DIRECT LINK TO CABINET is a direct output of the input signal, allowing you for example to simultaneously run your instrument through the GI100 and complete your normal signal path by connecting the DIRECT LINK to an amp or speaker cabinet. Check Out behringer.com for Full Manual