Belkin F7D4515 User Manual - Page 24

Troubleshooting and FAQs Distance and Placement Video and Audio ScreenCast AV can reach up to 100 feet (30m) line-of-sight and approximately 30 feet (10m) through barriers like walls, cabinets, and doors. Note: Please remember that every home is different and that the ranges above are estimates. Actual range will depend on the composition of the barriers and other factors. There are a variety of situations that could require slightly adjusting the position and/or placement of your ScreenCast AV transmitter and/or receiver. In most, if not all cases, an on-screen message will let you know if you need to adjust the location of your transmitter and/or receiver. When I switch sources, why does it often take a few seconds to bring the new source up on screen? Switching HDMI sources requires a number of "hand offs" to happen between your TV, your source device, and the ScreenCast AV system. Because of this, it may take up to 10 seconds for the HDMI sync to resolve. When I switch modes within my device (i.e., from Blu-ray disc playback to my BD player's menu), why does the ScreenCast AV system have to reconnect? Sometimes different modes of an AV device output content in different video resolutions; for instance, menus might be in 720p while a game or Blu-ray disc movie could be in 1080p. When the ScreenCast system switches resolutions, it needs to reconnect the transmitter and receiver, which is why you may experience a slight delay until the two units can sync again. My remote commands don't seem to work. Double-check that the IR emitter is fully seated in the back of the ScreenCast AV transmitter. You should also check to make sure that the receiver is flashing blue when you trigger a remote command- that means it is sending the command back to the transmitter. Finally, check to make sure that your remote batteries are fully charged and/ or fresh so that you get a full-strength signal from your AV remote. 22