Beltronics STi Driver Owner's Manual - Page 5
Installation - radar detection
UPC - 065789250015
View all Beltronics STi Driver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installation Power Connection To apply power to the STi DRIVER, plug the small end of the power cord, (telephonetype connector) into the modular jack on the STi DRIVER's right side, and plug the lighter plug adapter into your vehicle's lighter socket or accessory socket. Your STi DRIVER operates on 12 volts DC negative ground only. The lighter plug provided is a standard size and will work in most vehicles. However, some vehicles may require the optional European sleeve to ensure a snug fit. If so, simply call our service department and we'll send you one. This sleeve slides over the power cord's lighter plug adapter. Of course, your lighter socket must be clean and properly connected for proper operation. N0TE: Depending on your vehicle, the lighter socket power may either be continuously on, or it may be switched on and off with your ignition switch. We suggest using a direct-wire SmartPlug connected to a switched circuit at the fuse box if the lighter socket is continuously on. Mounting Location WARNING: BELTRONICS cannot anticipate the many ways STi DRIVER can be mounted. It is important that you mount STi DRIVER where it will not impair your view nor present a hazard in case of an accident. Where to mount STi DRIVER For optimum detection performance, we recommend the following: • Using the Windshield QuickMount, mount your STi DRIVER level, and high enough on your front windshield to provide a clear view of the road from the front and rear. • Mount the STi DRIVER away from windshield wipers, other solid objects, and heavily tinted areas that might obstruct the radar antenna or laser lens. 6 Windshield QuickMount The STi DRIVER's QuickMount windshield bracket is designed for unobtrusive and hassle-free mounting and removal. 1 Depress the adjustment button on the top of the STi DRIVER (by the word BELTRONICS) and slide the QuickMount bracket into the slot until it is locked into the position which best fits the angle of your windshield (there are four settings available). For extremely horizontal or extremely sloped windshields, the QuickMount bracket can be bent. To ensure that the suction cups adhere to the windshield firmly, be sure to keep both your windshield and the suction cups clean. 2 To adjust the STi DRIVER on your windshield, use the QuickMount adjustment button located on the top of the STi DRIVER, and slide the STi DRIVER forward or backward to obtain a level position. NOTE: When installed and adjusted properly, the back top edge of the STi DRIVER should rest solidly against your windshield. CAUTION: A few vehicles (including some Porsches) have windshields with a soft anti-lacerative coating on the inside surface. Use of suction cups will permanently mar this coating. Consult your dealership or the vehicle owner's manual to determine if your windshield has this coating. User's Tip You can leave the QuickMount bracket in place on your windshield, and easily remove STi DRIVER by pressing the adjustment button and sliding the STi DRIVER off the mount. Again, be sure to position the bracket where it won't present a hazard in the event of an accident. Additional mounts are available for other vehicles in your household. 7