BenQ CF110 User Guide - Page 3
Getting started - flash
View all BenQ CF110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Getting started Using the SIM card/battery Your phone's display is delivered with a protective film. Remove this film before getting started. The service provider supplies you with a SIM card on which all the important data for your account is stored. If the SIM card is credit card-sized, snap out the smaller segment and trim any rough edges. Always switch off phone before removing the battery! Only 3V and 1.8V SIM cards are supported. Please contact your service provider if you have an older card. Release and open battery cover 2 Close battery cover 4 Charge battery The battery is not fully charged when delivered. Plug charger cable into the bottom of the phone, plug power supply unit into a mains power socket and charge for at least two hours. The power supply unit heats up when used for long periods. This is normal and not dangerous. 1 Insert SIM card 3 When charging displayed. is in progress h is Charging time An empty battery is fully charged after about 2 hours. Charging is only possible within a temperature range of +5 °C to +40 °C. If the temperature rises/falls 5 °C above/below this, the charge symbol flashes a warning. The mains voltage specified on the power supply unit must not be exceeded (Operating time, p. 11). Charge level display during operation (empty - full): a d g. A beep sounds when the battery is nearly empty. The charge level of the battery is only displayed correctly after an uninterrupted charging/discharging cycle. You should therefore not remove the battery unnecessarily and where possible not terminate the charging process early. 3