BenQ MX717 DLP Projector User Manual - Page 35

1. Press MENU/EXIT and then press / until the SYSTEM SETUP: Basic menu is highlighted. 2. Press to highlight MyScreen and press ENTER. 3. Repeat steps 2-5 in the "Using the remote control" section to capture and view the captured picture. In the unlikely event that the capturing action fails, change your target picture. Large-sized pictures may cause the capturing action to fail. If so, please choose a smaller one and try again. Adjusting the sound The sound adjustments made as below will have an effect on the projector speaker. Be sure you have made a correct connection to the projector audio input. See "Connection" on page 17 for how the audio input is connected. Muting the sound To temporarily turn off the sound: 1. Press MENU/EXIT and then press / until the SYSTEM SETUP: Advanced menu is highlighted. 2. Press to highlight Audio Settings and press ENTER. The Audio Settings page displays. 3. Highlight Mute and press / to select On. If available, you can also press MUTE on the remote control to toggle projector audio between on and off. Adjusting the sound level To adjust the sound level, press VOLUME-/VOLUME+ or / , or: 1. Repeat steps 1-2 above. 2. Press to highlight Volume and press / to select a desired sound level. If available, you can also press MUTE on the remote control to toggle projector audio between on and off. Turning off the Power On/Off Ring Tone To turn off the ring tone: 1. Repeat steps 1-2 above. 2. Press to highlight Power On/Off Ring Tone and press / to select Off. The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound mute or changing the sound level will not affect the Power On/Off Ring Tone. Downloaded From projector-manual.com BenQ Manuals Operation 35