BenQ W1210ST User Manual - Page 39
System Setup : Advanced menu, Lamp Settings, Baud Rate, Test Pattern, Quick Cooling
View all BenQ W1210ST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
System Setup : Advanced menu Submenu Lamp Settings Functions and Descriptions • Reset Lamp Timer Activate this function only after a new lamp is installed. When you select Reset, a "Reset Successfully" message is displayed to notify that the lamp time has been reset to "0". • Lamp Timer Select to learn the duration (in hours) of lamp usage which is automatically calculated by the built-in timer. Total (equivalent) lamp hour = 2.0 x (hours used in Normal mode) + 1.4 x (hours used in Economic mode) + 1.0 x (hours used in SmartEco mode) • HDMI Range Selects a suitable RGB color range to correct the color accuracy. • Auto: Automatically selects a suitable color range for the incoming HDMI signal. • Full: Utilizes the Full range RGB 0-255. • Limited: Utilizes the Limited range RGB 16-235. HDMI Settings HDMI Range is only available when the HDMI signal is selected. • CEC When you connect an HDMI CEC-compatible device to your projector with an HDMI cable, turning on the HDMI CEC compatible device automatically turns on the projector, while turning off the projector automatically turns off the HDMI CEC compatible device. You can use the projector's remote control to control your HDMI CEC-compatible devices. See item 17 on page 10 for details. • Power On Link/Power Off Link When you connect an HDMI CEC-compatible device to your projector with an HDMI cable, you can set the behavior of powering on/off between the device and the projector. Bidirectional From Projector From Device Turning on/off either the connected device or the projector can turn on/off both. When the projector is turned on/off, the connected device will be activated/shut down, too. When the connected device is turned on/off, the projector will be activated/shut down, too. Baud Rate Test Pattern Quick Cooling Select a baud rate that is identical with your computer's so that you can connect the projector with a suitable RS-232 cable and update or download the projector's firmware. This function is intended for qualified service personnel. Enable this function to display the grid test pattern, which helps you adjust the image size and focus so as to check if the projected image is free of distortion. Select On to shorten the projector cooling time from a normal 90-second duration to approximately 15 seconds. Menu Functions 39