Beretta PX4 Storm Compact Beretta PX4 Storm Subcompact User Manual - Page 24

Reassembly

Get Beretta PX4 Storm Compact PDF manuals and user guides View all Beretta PX4 Storm Compact manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

frame (see Fig. 14). The recoil spring assembly can now be lifted out of the slide. Tilt the barrel by grasping the cam lug and remove the barrel from the slide. (See Fig. 15 and 16) CAUTION: No further disassembly is recommended unless done by a competent gunsmith. REASSEMBLY NOTICE: The numbers in the figures refer to the photos on page 44. Reassemble the pistol following the Field Stripping procedure in reverse order. • Reassemble by inserting the barrel into the slide. Tip the barrel to install the muzzle end through the hole in the front of the slide then lower the rear end into position in the slide. • Install the recoil spring assembly with the large flat end engaged into the recess in the barrel cam lug. (See Fig. 17). Install the slide assembly on the frame. While retracting the slide slightly, push in the takedown lever completely into the frame and rotate it clockwise to its horizontal position (See Fig. 18). • Retract the slide to check for correct operation. 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
frame (see Fig. 14). The recoil spring assembly can now be
lifted out of the slide. Tilt the barrel by grasping the cam lug
and remove the barrel from the slide. (See Fig. 15 and 16)
CAUTION:
No further disassembly is recommended unless done
by a competent gunsmith.
24
REASSEMBLY
NOTICE:
The numbers in the figures refer to the photos on page
44.
Reassemble the pistol following the Field Stripping procedure in
reverse order.
•Reassemble by inserting the barrel into the slide. Tip the
barrel to install the muzzle end through the hole in the front of
the slide then lower the rear end into position in the slide.
•Install the recoil spring assembly with the large flat end
engaged into the recess in the barrel cam lug. (See Fig. 17).
Install the slide assembly on the frame. While retracting the
slide slightly, push in the takedown lever completely into the
frame and rotate it clockwise to its horizontal position (See
Fig. 18).
•Retract the slide to check for correct operation.