Beretta Px4 Storm Full Size Beretta PX4 Storm Full Size User Manual - Page 39

! 81 HOW TO REVERSE THE MAGAZINE RELEASE BUTTON WARNING: Make sure the pistol is unloaded. If not, unload it following the "UNLOADING THE PISTOL" procedure. CAUTION: Before proceeding with the disassembly of the components, closely observe and memorize the location of the components to make assembly easier. CAUTION: These operations should be carried out by a competent gunsmith. NOTICE: It is advisable to perform field stripping and assembly operations over a table to catch components should they drop. NOTICE: The numbers in the figures refer to the photos on pages 86 and 87. • Remove the magazine. •Follow the instructions previously given to remove the magazine release button. • Insert the drift-punch and push the internal pin so it completely exits from its seat (Fig. 31). • Insert the drift-punch into the cavity from which you extracted the pin and press on the edge (protruding rim inside the hole) of the magazine button support until the support itself and the spring are removed. CAUTION: The spring is under tension. • Also remove the pin support from the opposite side (Fig. 32). • Reassemble the magazine button support with its spring on the opposite side of the pistol (Fig. 33) and, keeping it pressed down, insert the pin support into the other side (Fig. 34). A clear "click" advises that the parts are correctly assembled. • Position the magazine release button on the magazine button supports and, keeping them pressed down, completely insert the pin into its seat until it firmly engages the magazine release button (Fig. 35 and 36). • Try to remove the button from its seat to check that it is assembled properly.