Binatone Marina 900 User Manual - Page 2
Binatone Help Line - 0845 345 9677 - pmr
View all Binatone Marina 900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Monitor Mode Feature Your radio lets you listen for weak signals on the current channel at the press of a key. To turn on the Monitor Mode: • For brief listening, press MON. MON appears and RX flashes. • Press and hold MON for 2 seconds until two beeps sound for continuous listening. The receiver circuit stays open, so you hear both the noise and weak signals. To turn off Monitor Mode: Press MON to return to the previous mode. MON and RX disappear. Navigating through the Normal Menu To access the advanced features of your radio it has a Menu function. Note: Auto Channel Change (CHCX) only appears if your radio is set to Group Mode. Scan Mode Silent Mode Auto Channel Change Call Tone Unit Roger Beep Setting Beep Tone ON-OFF Channel Change 1-10 Setting Unit ON-OFF ON-OFF Number Start Scanning Setting Nickname 1) To enter the menu, press MENU. 2) Additional presses of MENU advances you through the menu. After the last menu item, the radio exits to the previous mode. 3) Other ways to exit the Menu function are: a. Press PTT, MON, CALL or TONE/GROUP. b. Wait 10 seconds until the radio automatically returns to the previous mode. Setting Silent Mode When you turn on the silent mode, all incoming calls are muted: the radio flashes the display backlight, the channel indicator, SLNT and CALL to alert you to an incoming call. If you do not respond to the call within 15 seconds, the backlight turns off. The radio will also vibrate to remind you that you missed a call. Silent mode is disabled for 15 seconds when you transmit, receive, or press any other button. To set the silent mode: 1) Enter the menu. Advance through the menu until the SLNT appears, then press ENTER/ . The current setting flashes. 2) Press CH to display on, or pressCH to display oF, then press ENTER/ . Binatone Help Line - 0845 345 9677 Note: To prevent unwanted silent alerts, be sure to use a Privacy code or group code whenever you use the Silent mode feature. You can hear the received voice when you turn on channel scan and an active channel is detected even during silent mode. Missed Call Alerts If you receive an incoming call while silent mode is on and do not respond, the radio will turn on the Missed Call icon. The radio will additionally remind you of a missed call by vibrating every minute after the call for 3 minutes. Transmitting a Call Tone Your radio is equipped with 10 selectable call tones that are transmitted when you press CALL in standard mode. The selected tone will be also heard when someone places a direct call to you. To select a call tone: 1) Enter the menu. Advance through the menu until CALL appears, then press ENTER/ . The current call tone number (1-10) flashes. 2) Press CH or to increase or decrease the number to the desired call tone. Each tone will be heard through the speaker. To transmit the selected call tone, press CALL. The selected tone is transmitted for a fixed length of time. Call Tone is cancelled if you press PTT. Roger Beep Roger beep is a beep that is sent to notify the end of transmission. You can hear the roger beep through the speaker when both roger beep and Beep Tone are on. When roger beep is on and Beep Tone is off, you do not hear the roger beep, but it is transmitted to your party. To set the roger beep, enter MENU. Advance through the menu until RGR appears, then press ENTER/ . The current setting flashes. To turn OFF roger beep: Press CH to display oF, then press ENTER/ . To turn ON roger beep: Press CH to display on, then press ENTER/ Adjusting the Sound (Beep Tone) . Your radio sounds a beep each time you press a key (except for PTT ). To set the sound, enter MENU. Advance through the menu until TONE appears, then press ENTER/ . The current setting flashes. To turn OFF this beep: Press CH to display oF, then press ENTER/ . To turn ON this beep: Press CH to display on, then press ENTER/ . Key Lock Press and hold the ENTER/ until the LOCK appears. To exit Keylock on mode, press and hold ENTER/ again until UNLK appears. Note: • While in keylock on mode, you can still use the radio to receive transmissions, use CALL in Standard mode, VOL or , PTT, MON and to turn on or off the radio. • The radio retains the keylock status even when you cycle power. Code 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 Freq. 77.0 79.7 82.5 85.4 88.5 91.5 94.8 97.4 100.0 103.5 107.2 110.9 114.8 118.8 123.0 127.3 Code 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 Freq. 151.4 156.7 162.2 167.9 173.8 179.9 186.2 192.8 203.5 210.7 218.1 225.7 233.6 241.8 250.3 Automatic Power Save Feature Your radio has a unique circuit designed to dramatically extend the life of the batteries. If there is no transmission nor an incoming call within 3 seconds, your radio switches to the Power Save mode. The radio is still able to receive transmissions in this mode. LCD Backlight The LCD Backlight automatically turns on when any key (except for PTT ) is pressed. The LCD remains lit for 10 seconds before turning off. SPECIFICATIONS Channels Sub Codes Operating Frequency Power Source Range Battery Life 8 channels 38 CTCSS Sub--Audible Tones 83 DCS Codes 446.00625 - 446.09375 MHz NiMH Battery Pack Up to 10 km 16 Hours typ. - NiMH Battery Pack (5/5/90 duty cycle) Frequency Chart Ch. Freq. [MHz] 1 446.00625 2 446.01875 3 446.03125 4 446.04375 Ch. Freq. [MHz] 5 446.05625 6 446.06875 7 446.08125 8 446.09375 CTCSS Chart (Hz) Code oFF 1 2 3 Freq. OFF 67.0 71.9 74.4 Code 20 21 22 23 Freq. 131.8 136.5 141.3 146.2 Binatone Help Line - 0845 345 9677 DCS Code List Code Octal No. Code 39 023 40 025 41 026 42 031 43 032 44 043 45 047 46 051 47 054 48 065 49 071 50 072 51 073 52 074 53 114 54 115 55 116 56 125 57 131 58 132 59 134 60 143 61 152 62 155 63 156 64 162 65 165 66 172 Code Octal No. Code 67 174 68 205 69 223 70 226 71 243 72 244 73 245 74 251 75 261 76 263 77 265 78 271 79 306 80 311 81 315 82 331 83 343 84 346 85 351 86 364 87 365 88 371 89 411 90 412 91 413 92 423 93 431 94 432 Code Octal No. Code 95 445 96 464 97 465 98 466 99 503 100 506 101 516 102 532 103 546 104 565 105 606 106 612 107 624 108 627 109 631 110 632 111 654 112 662 113 664 114 703 115 712 116 723 117 731 118 732 119 734 120 743 121 754 Effective Range The Transmission range of the product is dependent on the environment terrain where it is being used, the following diagram attempts to guide the user on the sort of performance to expect for everyday use. Signal Strength 0 Range(Km) 10 Optimum (open area) (1) Medium ground based obstruction (2) Heavily built up area (3) Range Slope Range Check The Transmission range will be affected as shown in the above diagram. The transmitting range typical values for different environment conditions will be (1) 10 km (2) 4 km (3) 2 km. It should be remembered that these are only guide values as actual achieved distances will be dependent on the environment and terrain. Binatone Helpline (for UK only) Monday to Friday from 9:00am to 5:00pm Tel: 0845 345 9677 **Please note that all calls are charged at local rate or visit our website: www.binatonetelecom.com GUARANTEE The Binatone Marina 900 is fully guaranteed for 12 months from the date of purchase shown on your sales receipt. The guarantee does not cover damage by misuse or negligence or by excessive voltage. Please keep your sales (till) receipt - this is your guarantee.You should also keep the original packaging materials. When unpacking your Binatone Marina 900, check for visible damage. If you see any damage, do not use the PMR - return the whole unit to where you bought it. If your Binatone Marina 900 develops a fault, and you can't solve the problem, return the whole unit as follows; While the unit is under guarantee 1. Pack up all the parts of your Marina 900 ,using the original packaging.Remember to include the mains adapter and charger. 2. Return the unit to the store where you bought it, and make sure you take your sales receipt as your proof of purchase. 3. In the unlikely event that you need to return your Marina 900 to our Repair Centre while it is under Guarantee, please include the sales receipt. There may be a handling charge for repair of unit under Guarantee. Repair after the Guarantee has expired If the unit is no longer covered by Guarantee, first follow step 1 as for repair under Guarantee, Then... 2. Call our service Department on 0845 345 9677 and ask for a quotation of the repair charge, and details of where to send your Marina 900 for repair. 3. Return your Marina 900 to the address given by the Service Department, making sure to include your name and address, and a cheque or postal order for the value of the repair charge. This does not affect your statutory rights. Binatone Telecom plc operates a policy of continuous product improvement, and so reserves the right to make changes to the product and functions without prior notice. BINATONE TELECOM PLC 1 Apsley Way London NW2 7HF,United Kingdom. Tel:+44(0)2089552700 Fax:+44(0) 208344 8877 e-mail:[email protected] EC Declaration of Conformity We the manufacturer / Importe:r Binatone Telecom Plc 1 Apsley Way London NW2 7HF, United Kingdom. Declare under our sole responsibility that the following product Type of equipment: Private Mobile Radio Model Name: Marina 900 Series Country of Origin: China Brand: Binatone complies with the essential protection requirements of R&TTE Directive 1999/5/EC on the approximation of the laws of the Council Directive 2004/108/EC on the approximation of the laws of the Member States relating to electromagnetic compatibility (EMC) and the European Community Directive 2006/95/EC relating to Electrical Safety. Assessment of compliance of the product with the requirements relating to the essential requirements according to Article 3 R& TTE was based on Annex III of the Directive 1999/105/EC and the following standard: EMC&RF: EN 301- 489-5 V1.3.1:(2002-08) EN 301- 489-1 V1.8.1:(2008-04) EN 300-296-1 V1.1.1:(2001-03) EN 300-296-2 V1.1.1:(2001-03) EN 300-341-1 V1.3.1(200012) EN 300-341-2 V1.1.1(200012) Electrical Safety: EN 60950-1:2006 Waste electrical products must not be disposed of with household waste. This equipment should be taken to your local recycling centre for safe treatment. The product is labelled with the European Approval Marking CE as show. Any Unauthorized modification of the product voids this Declaration. Manufacturer / Importer (signature of authorized person) Signature: London, Place & Date: 8th Aug, 2010 Binatone Help Line - 0845 345 9677 Binatone Help Line - 0845 345 9677 Printed in Vietnam BTP ver 1.0 Aug-10 UTZZ01053AZ(0) UT053AK_Marina 900_0810.indd 2 8/11/2010 2:41:07 PM