Biostar IDEQ 200T iDEQ 200T BIOS setup guide - Page 17
Onboard Device - raid driver
View all Biostar IDEQ 200T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
P4TBA BIOS Setup interface. Select "Disabled" to deactivate an interface if you are going to install a primary and/or secondary add-in IDE interface. The Choices: Enabled (default), Disabled. IDE Primary / Secondary Master / Slave PIO The IDE PIO (Programmed Input / Output) fields let you set a PIO mode (0-4) for each of the IDE devices that the onboard IDE interface supports. Modes 0 through 4 provides successively increased performance. In Auto mode, the system automatically determines the best mode for each device. The Choices: Auto (default), Mode0, Mode1, Mode2, Mode3, Mode4. IDE Primary / Secondary Master / Slave UDMA Ultra DMA/100 functionality can be implemented if it is supported by the IDE hard drives in your system. As well, your operating environment requires a DMA driver (Windows 95 OSR2 or a third party IDE bus master driver). If your hard drive and your system software both support Ultra DMA/100, select Auto to enable BIOS support. The Choices: Auto (default), Disabled. SATA Mode The Choices: IDE (default), RAID. On-Chip Serial ATA This item allows you to enable or disable the On-Chip Serial ATA. The Choices: Auto (default), Disabled, Combined Mode, Enhanced Mode, SATA only. Serial ATA Port 0 Mode The Choices: Primary Master (default), Primary Slave, Secondary Master, Secondary Slave, Primary Master, Secondary Master, SATA0 Master, SATA1 Master. Onboard Device Press Enter to configure the onboard Device. USB Controller Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have USB peripherals. The Choices: Enabled (default), Disabled. USB 2.0 Controller This entry is for disable or enable EHCI controller only. This BIOS itself may/ may not have high speed USB support. If the BIOS has the high speed support built in, the support will be automatically turned on when high speed devices are attached. The Choices: Enabled (default), Disabled. 16