Biostar M7VIK M7VIK user's manual - Page 8

Jumpers, Headers, Connectors & Slots Hard Disk Connectors: IDE1/ IDE2 The motherboard has a 32-bit Enhanced PCI IDE Controller that provides PIO Mode 0~4, Bus Master, and Ultra DMA 33/ 66/ 100/ 133 functionality. It has two HDD connectors IDE1 (primary), IDE2 (secondary) and IDE3. The IDE connectors can connect a master and a slave drive, so you can connect up to four hard disk drives. The first hard drive should always be connected to IDE1. Serial ATA Connector: (JSATA1/ JSATA2) (Optional) The motherboard has a PCI to SATA Controller with 2 channels STAT interface, it satisfies the SATA 1.0 spec and can transfer data with 1.5GHz speed. Raid Connector: RAID1 This connector supports RAID 1 cofiguration through the onboard Serial ATA controller chip. You can use the IDE feature to set up a disk array cofiguration and to support additional IDE devices. However, it can only support master mode IDE HDD. Floppy Disk Connector: FDD1 The motherboard provides a standard floppy disk connector that supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector supports the provided floppy drive ribbon cables. Accelerated Graphics Port Slot: AGP1 (only support AGP power 1.5V) Your monitor will attach directly to that video card. This motherboard supports video cards for PCI slots, but it is also equipped with an Accelerated Graphics Port (AGP). An AGP card will take advantage of AGP technology for improved video efficiency and performance, especially with 3D graphics. Communication Network Riser Slot: CNR1 The CNR specification is an open Industry Standard Architecture, and it defines a hardware scalable riser card interface, which supports audio, network and modem only. 6