Biostar M7VIW D M7VIW D compatibility test report - Page 51
Vcore Transient waveform
View all Biostar M7VIW D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
CPU CH 1 Condition Vcore Ripple Test(Open up the DOS Editor) Athlon_xp_2400+ M\B VIW1.0 Vcore CH 2 STPCLK 1.Boot the system to the Win98SE environment(Command Prompt Only) Dos mode and run the stpclk.bat 2.At the main menu ,type Enter & Enter & "Y" to go to the "menu" 3.At the next menu , select "Power Management Utilities" 4.At this menu , select "Throttle Ratio" and set at the rang of 50.0%~56.0% and set "Enable" of " ON" 5.Press tiwce and then "Y" to exit the stpclk.bat program. 6.Type "EDIT" to enter the "EDIT" pragram. Press "Alt+F" to open up a Pop-up menu. 7.Measure the Vcore waveform Vcore Transient waveform RESULT PASS 51
51
Vcore Ripple Test(Open up the DOS Editor)
CPU
Athlon_xp_2400+
M\B
VIW1.0
CH 1
Vcore
CH 2
STPCLK
Condition
1.Boot the system to the Win98SE environment(Command Prompt Only)
Dos mode and run the stpclk.bat
2.At the main menu ,type Enter & Enter & “Y”
to go to the “menu”
3.At the next menu , select “Power Management Utilities”
4.At this menu , select “Throttle Ratio”
and set at the rang of
50.0%~56.0%
and set “Enable”
of
“ ON”
5.Press <ESC> tiwce and then “Y” to exit the stpclk.bat program.
6.Type “EDIT” to enter the “EDIT” pragram. Press “Alt+F” to open up a
Pop-up menu.
7.Measure the Vcore waveform
Vcore Transient waveform
RESULT
PASS