Biostar P43-A7 Setup Manual - Page 26

Motherboard Manual Notices: Not all types of Intel CPU perform above overclock setting ideally; the difference will be based on the selected CPU model. B. Memory Integration Test (M.I.T.) This function is under "Overclocking Navigator Engine" item. MIT allows users to test memory compatibilities, and no extra devices or software are needed. Step 1 The default setting under this item is "Disabled"; the condition parameter should be changed to "Enable" to proceed this test. Main Advanced PCIPnP BIOS SETUP UTILITY Boot Chipset O.N.E Exit Over-Clocking Navigator setting WARNING: Setting wrong values in below sections may cause system to malfunction. Over-Clocking Navigator [Normal] =========== Automate OverClock System =========== Auto OverClock System [V6-Tech Engine] Manual OverClock System Intel(R) SpeedStep(tm) tech [Enabled] Ratio CMOS Setting [ x10.0] CPU Frequency Setting [266] Over Clock Retry Count [3] FSB(Bsel) To NorthBridge Latch [Auto] DRAM Frequency [Auto] DDR2 Enhanced Mode [Auto] > DRAM Timing Configuration > Clock Gen Configuration > ALL Voltage Configuration Memory Test [Disabled] Options Disabled Enabled Select Screen Select Item EnterGo to Sub Screen F1 General Help F10 Save and Exit ESC Exit vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc. ↓ Main Advanced PCIPnP BIOS SETUP UTILITY Boot Chipset O.N.E Exit Over-Clocking Navigator setting WARNING: Setting wrong values in below sections may cause system to malfunction. Over-Clocking Navigator [Normal] =========== Automate OverClock System =========== Auto OverClock System [V6-Tech Engine] Manual OverClock System Intel(R) SpeedStep(tm) tech [Enabled] Ratio CMOS Setting [ x10.0] CPU Frequency Setting [266] Over Clock Retry Count [3] FSB(Bsel) To NorthBridge Latch [Auto] DRAM Frequency [Auto] DDR2 Enhanced Mode [Auto] > DRAM Timing Configuration > Clock Gen Configuration > ALL Voltage Configuration Memory Test [Enabled] Options Disabled Enabled Select Screen Select Item EnterGo to Sub Screen F1 General Help F10 Save and Exit ESC Exit vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc. Step 2 Save and Exit from CMOS setup and reboot the system to activate this test. Run this test for 5 minutes (minimum) to ensure the memory stability. Step 3 When the process is done, change the setting back from "Enable" to "Disable" to complete the test. 24