Bissell Big Green Machine Professional Carpet Cleaner 86T3 User Guide - Page 11

Page 11 highlights

Maintenance & Care Brush removal and replacement 1. Turn OFF (0) the machine and unplug from the outlet. 2. Remove the dirty and clean water tanks from the base of the machine. 3. While standing behind the unit, lay the unit on its' side (cord side down). 4. Looking at the bottom of the unit, find the center of the brush carriage where the carriage latch is located. It is between the brush assembly and wheels. 5. Pull the brush carriage towards you with one hand until it stops. Pinch the carriage latch with the other hand while pulling the carriage towards you. The carriage should swing out to access brush end cover. 6. Remove three screws from endcap. Pull endcap off to release brush roll. 7. With cover removed, the brush comes out easily by tilting the loose end out of the carriage. 8. To replace the brush roll back into the unit, place the large open end of the brush onto the carriage and tilt opposite end back into place. 9. With the brush sitting relatively straight up and down by itself, place endcap back on top and replace three screws. The brush will need to be held and centered to the cover while placing it back on. 10. Spin the brush by hand to make sure it turns freely with some minor resistance from the motor. Push brush carriage back into place with a light pull against the lock. WARNING To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. 3. 4. 5. 6A. 6B. 7. 8. 9. 10. www.bissell.com 800.237.7691 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
Mainµn°ce & Care
Brush removal and replacement
1.
Turn OFF (0) the machine and unplug from
the outlet.
2.
Remove the dirty and clean water tanks from
the base of the machine.
3.
While standing behind the unit, lay the unit
on its’ side (cord side down).
4.
Looking at the bottom of the unit, find the
center of the brush carriage where the carriage
latch is located. It is between the brush
assembly and wheels.
5.
Pull the brush carriage towards you with
one hand until it stops. Pinch the carriage latch
with the other hand while pulling the carriage
towards you. The carriage should swing out to
access brush end cover.
6.
Remove three screws from endcap. Pull
endcap off to release brush roll.
7.
With cover removed, the brush comes
out easily by tilting the loose end out of the
carriage.
8.
To replace the brush roll back into the unit,
place the large open end of the brush onto the
carriage and tilt opposite end back into place.
9.
With the brush sitting relatively straight up
and down by itself, place endcap back on top
and replace three screws. The brush will need
to be held and centered to the cover while
placing it back on.
10.
Spin the brush by hand to make sure it
turns freely with some minor resistance from
the motor. Push brush carriage back into place
with a light pull against the lock.
4.
5.
6A.
7.
9.
10.
6B.
8.
3.
WARNING
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
www.BISSELL.com
800.237.7691
11