Bissell PowerForce® Helix™ Turbo Bagless User Guide - Page 6
ssembly, Attach handle to vacuum, Attach vacuum hose and tools
View all Bissell PowerForce® Helix™ Turbo Bagless manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Assembly Attach handle to vacuum 1. Locate handle and remove screw packet taped to the base of the handle. 2. Stand the vacuum upright and place the base of the handle firmly into the grooves at the top of the vacuum body. 3. Insert the two (2) screws into the existing holes on each side and tighten securely. Attach vacuum hose and tools 1. Line up tabs on the base of the Twist 'n Snap™ hose with the corresponding notches on the hose collar. Turn the hose to the right to lock into place. 2. Grasp the Quick Reach handle and slide the end of the hose into the hose wand base. Snap the hose into the upper hose clip on handle. 3. Slide the extension wand and crevice tool together into storage clip. 4. Snap the combination tool into the storage clip. Select models only: 5. The TurboBrush® Tool bracket slides into the front of the handle. Attach the bracket by aligning the pegs with the holes on the handle and pulling down until it locks into place. 6. Place the TurboBrush® Tool in the bracket by aligning the bottom of bracket with the opening of the brush roll and snap the TurboBrush® Tool into place. 1 Tip: Hold onto the plastic hose collar while installing. It may be easier to lock the hose into place when the hose handle is not yet inserted into the base of the unit. 1 ! WARNING: Plastic packaging can be 5 6 dangerous. To avoid danger of suffocation, keep away from babies and children. 6