Bissell PowerGlide® Pet Vacuum 1044 User Guide - Page 12
Check rotating floor brush, and drive belt, Cleaning the pre-motor filter & replacing the post-
View all Bissell PowerGlide® Pet Vacuum 1044 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Maintenance and care Cleaning the pre-motor filter & replacing the post-motor filter 1. Unplug the vacuum from electrical outlet. 2. The pre-motor filter protects the motor from dirt particles. It is located in the slide out tray underneath the dirt container. Check the pre-motor filter at least once a month. If the filter becomes dirty, pull out the tray, lift out the foam filter pad and clean it. Washable Pre-Motor Filter NOTE: The pre-motor filter may be hand washed in water with mild detergent. Rinse well and air dry thoroughly before replacing. NOTE: Use of moist parts/components in your unit will damage the motor and void your warranty. 3. The post-motor filter assists in the filtration process to return clean air to the room. It is located behind the door on the side of the vacuum. If the filter becomes dirty, open the door, remove the filter and replace. Febreze® Post-Motor Filter WARNING: To reduce the risk of injury from moving parts, turn vacuum cleaner off and disconnect power plug from electrical outlet. 4. The Febreze® filter is designed to eliminate odors during the regular life of the filter. Depending on usage, the post-motor filter should be changed every 3-6 months. NOTE: The post-motor filter is a white, pleated filter. This filter is not washable and must be replaced when it becomes dirty. WARNING: Do not operate cleaner with damp or wet filters or without all filters in place. Check rotating floor brush and drive belt You should check your vacuum cleaner's rotating floor brush and drive belt regularly for wear or damage. You should also clean the brush and brush ends of strings, hair and carpet fibers. This type of debris can wrap around the brush and hamper its ability to effectively clean your carpet. Also remove any debris that has accumulated under the brush cover. 3. 1 1. Unplug the vacuum from electrical outlet. 2. Place handle in low position and turn vacuum cleaner over so bottom side is facing up. 4 2 3 3. Lift tab 1 and release the three latches in order 2-4 marked. Lift off the brush cover. 12 w w w. b i s s e l l . c o m 800.237.7691