Bissell ProHeat 2X Revolution Pet Pro Carpet Cleaner 1986 User Guide - English - Page 19

Replacing Belts & Brush Rolls (Continued) 6 There are washers at the ends of the brush rolls, be careful that these do not fall off or get lost. NOTE: To replace brush rolls, remove them from the metal posts and replace. Make sure the metal post goes completely through the end of the brush roll. The brush roll bristles should be aligned in a 'V' pattern as pictured. Align brush rolls with belt at other end. To ensure alignment, hold the end of one brush roll and twist. The other brush roll rotates with it. Check that washers are in place. Reassemble the belt and end cap, securing with screws you removed. 7 If the flat belt is broken, 8 gently remove the belt. If it needs replacing for any reason, the gear belt should already be removed before removing the flat belt. Rotate the machine back to its side. Feed the new flat belt through the opening so that it wraps around the red pulley. Keep it wrapped on the red pulley and adjust the machine so it is laying on it's back again. Use your thumb to stretch the flat belt back to wrap around the metal axle. 9 10 Resecure the Wheel and Belt Access Door: Slide the wheel up back into the slot and secure with the screw that was removed. Snap the Belt Access Door back down into place. NOTE: See Step 6 on page 18 for how to put the brush roll cover and nozzle back in place. www.BISSELL.com 19