Bissell SpotClean 5207A User's Guide - Page 7

Operations Cleaning with your spot cleaner 1. Plug the unit in and turn on by pressing button under handle. 2. Hold the tool approximately 1" above the soiled surface. When using the Deep Reach Tool (select models), keep the tool in contact with the carpet while spraying. Press the spray trigger to apply the cleaning solution to the soiled area. 3. Using the brush on the tool, gently scrub the area to be cleaned. 4. For thorough cleaning, spray additional solution while the brush and suction are in contact with the surface. 5. Apply downward pressure on the tool and pull it toward you. The suction will remove the dirt and cleaning solution. Continue until no more dirt can be removed. 6. As a final step, use "drying strokes" (by not pressing the spray trigger) to remove as much liquid/moisture as possible. Repeat this step as often as necessary. WARNING Keep spray away from face. Failure to do so may result in personal injury. Important Check the manufacturer's tag before cleaning upholstery. "W" or "WS" on the tag means you can use your SpotClean. If tag is coded with an "S" (with diagonal strikethrough), or says "Dry Clean Only," do not proceed. If manufacturer's tag is missing or not coded, check with your furniture dealer. Cleaning with the Stain Trapper tool (select models) Your deep cleaner may have come with a Stain Trapper tool. This tool is great for keeping messes out of the machine's hose system. 1. Attach the Stain Trapper tool to the end of the hose. 2. Slowly move the tool back and forth over the stain. Be careful not to move the tool back and forth too quickly or soiled water will flow back into the hose. 3. To empty the Stain Trapper tool, rotate the small tank on the bottom of the tool 3 . to unlock it. NOTE: Be careful to keep the top of the tool facing upward or soiled water will spill out of the tank, and into the hose. 4. Dump dirty water into a sink or toilet and rinse the tank out with clean water. Replace the tank by lining up the locking teeth with their mating slots (make sure the two teeth that are closest together are pointed toward the brush). Turn the tank to lock it into place. 5. Clean the front of the tool by removing the 5. plate over the suction path. Pull down on the plate to remove. Run the tool and the plate under clean water to rinse taking care to remove all debris. Replace the front plate by sliding it back into place. www.bissell.com 800.237.7691 7