Bissell Total Floors® Pet Vacuum User Guide - Page 6

www.bissell.com

800.237.7691

A

ssembly

6

Attach the vacuum hose & tools continued

(B)

A

c.

The hose guide/tool caddy should be

attached at the bottom of the back of

the vacuum. Slide into place and insert

screw into the existing hole. Tighten

securely with a Phillips screwdriver.

2.

Line up the tabs of the Twist n’ Snap hose with the

corresponding notches and turn clockwise. Slide

the end of the hose into the hose wand base.

Hose wraps on back of unit as shown on page 4.

3.

Place the TurboBrush Tool or Pet TurboEraser

Tool into its holder from the front of the vacuum.

Power cord

To store the power cord, wrap cord around the

upper and lower cord wrap on the side of the

vacuum. To release the power cord, rotate the

upper cord wrap down and gently pull off cord.

Power switch

The power switch is located just below the

carrying handle on the side of the vacuum.

Push the rocker switch

“ON” (I)

to vacuum,

and

“OFF” (O)

when cleaning is complete.

Brush Roll Power

The rotating brush ON/OFF pedal is located on

the foot of the vacuum. You can use your foot to

engage or disengage this pedal (A). When the

brush roll pedal has been engaged, the brush

will start rotating. The brush roll should be turned

on for most carpeted floors. To turn the brush roll

off, disengage the pedal by pressing on it with

your foot.

We recommend turning off the brush

roll for bare floor cleaning to prevent scatter or

for other delicate surfaces.

Edge Suction

To make edge cleaning more convenient,

remove the hose from the hose wand base

and attach the crevice tool. Insert the crevice

tool into the port on the foot of the vacuum (B).

Suction is now diverted to the front corner of

the vacuum and you can clean along edges

and into corners. It is recommended you turn

off the brush roll when using this feature.

CAUTION:

Before using your vacuum,

make sure that the dirt con-

tainer is in the locked position

and that all filters (pre-motor

and post-motor) are in place.

Do not operate your vacuum

without these filters.

NOTICE:

The brush roll continues to rotate while

using your vacuum for above floor

cleaning. To prevent carpet damage,

turn the brush roll off and do not lean

on vacuum or tilt forward.

Tip:

Your vacuum features a quick-

release cord wrap.

To remove the

power cord quickly and easily,

rotate the upper cord wrap towards

the floor, and slip the cord off.

Tip:

Do not use extension wand when

using the Edge Suction Feature.

Bissell Total Floors® Pet Vacuum User Guide - Page 6

Caution, Notice - brush

Page 6 highlights