Bosch B22CS30SNS Instructions for Use - Page 7

Installation m WARNING m Excessive Weight! - Keep doors taped closed until refrigerator is completely installed. - Use two or more people to move and install refrigerator. Failure to do so can result in death or serious injury. m WARNING m Do not install the appliance: - outdoors, - in an environment with dripping water, - in rooms which are at risk of frost. Installation location m WARNING m Explosion Hazard Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Failure to do so can result in death, explosion or fire. Install the appliance in a dry, well ventilated room. The installation location should neither be exposed to direct sunlight nor near a heat source, e.g. a cooker, radiator, etc. If installation next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances to a heat source: - 11/4" (3 cm) to electric or gas cookers. - from an oil or solid-fuel cooker 113/16" (30 cm). If installing the appliance next to another refrigerator or freezer, there must be a minimum gap of 1" (25 mm) between the appliances in order to prevent condensation. If a panel or cupboard is installed above the appliance, ensure that a gap of 11/4" (30 mm) is left so that the appliance can be pulled out of the recess if required. The air heated on the rear side of the appliance must be allowed to escape unhindered. Subsurface The appliance is very heavy - empty weight of appliance with dispenser: 317 Ibs / 143 kg. The floor on which the appliance is to be installed must be rigid. If required, reinforce the floor. To ensure that the doors can open all the way, observe lateral minimum distances when installing the appliance in a corner or recess (see section on "Appliances and installation dimensions"). If the depth of the adjacent kitchen equipment is more than 223/8" (60 cm), observe lateral minimum distances in order to utilise the full door opening angle (see section "Door opening angle"). Observe ambient temperature and ventilation Room temperature The climatic class can be found on the rating plate. It states the room temperature within which the appliance can be operated. Climati c class SN N ST T Permitted ambient temperature +50 °F to 89.6 °F (+10 °C to 32 °C) +60.8 °F to 89.6 °F (+16 °C to 32 °C) +60.8 °F to 100.4 °F (+16 °C to 38 °C) +60.8 °F to 109.4 °F (+16 °C to 43 °C) Ventilation Never cover the ventilation openings on the rear panel. Otherwise the refrigerating unit must work harder, increasing the power consumption. Place the enclosed spacers in the designated holders on the back of the appliance. This ensures that there is a minimum distance between the appliance and the wall. Electrical requirements m WARNING m Avoid Electrical Shock Hazard - Plug into a grounded 3 prong outlet. - Do not remove ground prong. - Do not use an adapter. - Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Improper connection of the equipment grounding conductor may result in electric shock. Have the appliance checked by a qualified electrician or service technician if you are in doubt as to whether the appliance has been properly grounded. A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded electrical supply is required. The appliance comes with an UL listed, 3-wire power supply cord. The appliance requires a 3-wire receptacle. Use an receptacle that cannot be turned off by a switch. The receptacle must be installed by a licensed electrician only. 7