Bosch DVR6E1082 Installation Instructions - Page 36
Keyboard connections
View all Bosch DVR6E1082 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Divar | Installation Manual | Hardware setup Keyboard connections The keyboard input and output connectors are used to connect an external keyboard to the unit. Connect the keyboard to the KBD IN connector. Up to 4 external keyboards can be connected when the optional keyboard port expander (LTC2604) is used. For short distances (up to 30m), standard 6-core telecom flat cable can be used to supply power and signal connections for the keyboard. For distances over 30m between keyboard and Divar, the Keyboard Extension Kit (LTC 8557) must be used. This kit provides junction boxes, cables and the appropriate power supply for the external keyboards. The recommended cable type is Belden 9841 or equivalent. Divar connection The KBD IN and KBD OUT connectors can also be used to connect several Divar units to each other. The loop-through connector arrangement allows easy interconnection of up to 30 Divars. The connection uses RS485-based communications. The RS485 connection is not galvanically separated. If you have an installation where Divars are connected via RS485 and they are not located close to each other, you must ensure that they are grounded via the same, clean grounding wire. Specifications Communicaton protocol: Maximum signal voltage: Power supply: Maximum cable length: Cable type: Termination: RS485 ± 12V 11 - 12.6V, maximum 400mA 1.5 kilometers black (cross-over) cable (supplied with keyboard) 390 Ohm terminator Keyboard In - RJ11 socket (KBD IN) Pin no. 1 2 3 4 5 6 Signal +12 V DC (11V Min to 12.6V Max, 400mA Max) System ground Keyboard plus line Keyboard minus line System ground System ground Keyboard out - RJ11 socket (KBD OUT) Pin no. 1 2 3 4 5 6 Signal No Connection System ground Keyboard minus line Keyboard plus line System ground No Connection 6 1 42 EN | 4-4 Panel view Bosch Security Systems