Bosch HDI7132U Use & Care Manual - Page 45
Self Cleaning the Oven, Preparing the Oven for Self Clean, Recommendations
View all Bosch HDI7132U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Table 12: Oven Cleaning Chart Cleaning and Maintenance Part Stainless Surfaces Plastic & Controls Recommendations Always wipe or rub with grain. Clean with a soapy sponge then rinse and dry, or wipe with Fantastik® or Formula 409® sprayed onto a paper towel. Protect and polish with Stainless Steel Magic® and a soft cloth. Remove water spots with a cloth dampened with white vinegar. Use Bar Keeper's Friend® to remove heat discoloration. When cool, clean with soapy water, rinse and dry. Self Cleaning the Oven The oven features a self-cleaning function that eliminates the manual labor involved with cleaning your oven. During self-cleaning, the oven uses a very high temperature to burn away food soil and grease. Preparing the Oven for Self Clean • Do not clean parts or accessories in the self-clean oven. • It is common to see smoke and/or an occasional flame-up during the Self- Clean cycle, depending on the content and amount of soil remaining in the oven. If a flame persists, turn off the oven and allow it to cool before opening the door to wipe up the excessive food soil. • The oven door locks at the beginning of the self-clean cycle. • The oven light does not operate during this mode. • During Self-Clean, the kitchen should be well ventilated to help eliminate odors associated with Self-Clean. Odors will lessen with use. • Four hours is the preset length of cleaning. The range can also be set to clean for 3 or 5 hours. • The mode automatically stops at the end of the clean hours. • When the oven cools after cleaning, the automatic door lock will release and the door can be opened. • To cancel or stop while the mode is operating, press OFF. • The door will not unlock until the oven reaches a safe temperature. WARNING: A flexible door gasket is necessary for a good seal. Do not clean, rub, damage or move the gasket. 1. Remove all utensils and bakeware. 2. Remove oven racks. If oven racks are left in the oven during the self-clean cycle, they will permanently lose the shiny finish and change to a dull dark finish. See "Oven Cleaning Chart" on page 42 for proper care. 3. Wipe up excessive soil, spills and grease before self-cleaning the oven. Excess grease will cause flames and smoke inside the oven during selfcleaning. English 43