Bosch SGX68U55UC Instructions for Use - Page 22

Troubleshooting Guide Dishwashers may occasionally exhibit problems that are unrelated to a malfunction of the dishwasher itself. The following information may help you with a dishwasher problem without involving a repair professional. Problem Cause Dishwasher does not start 1. Door may not be properly latched. 2. Unit may not be turned on. 3. Unit not reset or previous cycle not completed. 4. Delay start engaged. 5. Interruption of electrical power supply to dishwasher or blown fuse. 6. The door may have been closed without first selecting a cycle. 7. Water supply may not be turned on. Dishwasher 1. Default factory settings alert the cus- beeping tomer that the cycle is complete by beeping. (end of cycle This feature can be deactivated if so desired. signal) 2. Water connection is lost. Display does 1. A fuse may have been blown or circuit not illumi- breaker tripped. nate or con- 2. Door not closed or latched. sole lights are not on Dishwasher 1. Incoming water is not warm enough. seems to run 2. Cycle time can vary due to soil and water a long time conditions. 3. Rinse aid dispenser is empty. 4. Dishwasher connected to cold water supply. Note: Refer to "Wash Cycle Information" section in this manual for typical cycle lengths. Dishes are not getting clean enough 1. Spray arm movement obstructed. 2. Spray arm nozzles clogged. 3. Improper use of detergents. 4. Filters could be clogged. 5. Dishes are nested or loaded too close together. 6. Selected wash cycle is not suitable for food soil conditions. Action 1. Shut the door completely. 2. Press the main power switch to turn unit on. 3. To reset, refer to "Operating the Dishwasher" in this manual. 4. To reset, refer to "Delay Start" section in this manual. 5. Check circuit breaker. 6. Select a cycle and press start. 7. Check and turn on water supply. 1. To adjust the volume or deactivate, refer to the "Cycle Completion Signal" section in this manual. 2. Check and turn on water supply. 1. Check the fuse or circuit breaker box and replace the fuse or reset the breaker if necessary. 2. Ensure door is properly latched and completely closed. 1. Before starting a cycle, run hot water faucet at the sink closest to the dishwasher. 2. Sensors in the dishwasher automatically increase the cycle time to ensure a good wash when heavy soil is detected. 3. Add rinse aid. 4. Verify dishwasher is connected to hot water supply plumbing. 1. Ensure that spray arm movement is not blocked by hand rotating spray arms before starting cycle. 2. Remove the spray arms and clean according to the "Care and Maintenance" section of the manual. 3. Increase or decrease detergent depending on the water hardness (refer to Table 1). 4. Clean the filters according to the "Care and Maintenance" section of the manual. 5. Rearrange load such that water spray can reach all items in the dishwasher - see "Loading the Dishwasher" section of the manual. 6. Refer to "Wash Cycle Information" section of the manual. 20