Bosch SHE3AEM6N Installation Instructions - Page 8

Attach Drain Hose, Pre-level the Dishwasher

Get Bosch SHE3AEM6N PDF manuals and user guides View all Bosch SHE3AEM6N manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

en-us Installation Procedure 4. Attach the hot water line to the elbow. Use two wrenches to tighten, using one to stabilize and avoid putting stress on the water inlet valve. 2. Raise the front of the dishwasher to approximately 1/2" lower than the height of the opening by turning all three feet. The maximum height the unit can be raised to is 34.5" (867.3 mm) 3. Use a level on the top front to see that the feet are even. 4. Once the unit is at a satisfactory height, insert a leg leveler locking screw in back foot. 4.2 Attach Drain Hose 1. Flip unit back upright, making sure the waterline is not pinched. 2. Facing the back of the unit, orient the drain hose toward direction of sink. IMPORTANT: Route hose toward sink PRIOR TO connection. Do not turn after attachment. 3. Attach drain hose elbow to back of unit using pliers to install the spring clamp 4.3 Pre-level the Dishwasher Set the dishwasher to the correct height before it goes into the cabinet. 1. Measure the height of the cabinet opening. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
en-us
Installation Procedure
8
4.
Attach the hot water line to the elbow. Use two
wrenches to tighten, using one to stabilize and avoid
putting stress on the water inlet valve.
4.2
Attach Drain Hose
1.
Flip unit back upright, making sure the waterline is not
pinched.
2.
Facing the back of the unit, orient the drain hose toward
direction of sink.
IMPORTANT: Route hose toward sink PRIOR TO
connection. Do not turn after attachment.
3.
Attach drain hose elbow to back of unit using pliers to
install the spring clamp
4.3
Pre-level the Dishwasher
Set the dishwasher to the correct height before it goes into
the cabinet.
1.
Measure the height of the cabinet opening.
2.
Raise the front of the dishwasher to approximately 1/2"
lower than the height of the opening by turning all three
feet.
The maximum height the unit can be raised to is 34.5"
(867.3 mm)
3.
Use a level on the top front to see that the feet are
even.
4.
Once the unit is at a satisfactory height, insert a leg
leveler locking screw in back foot.