Bosch WAP24201UC Instructions for Use - Page 12
Remove the transport bolts, Water connections
View all Bosch WAP24201UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Remove the transport bolts 9 CAUTION DAMAGE TO THE APPLIANCE ▯ The machine is secured for transport with transport bolts. Transport bolts that are not removed can damage the drum during operation of the machine, the washer will vibrate, and it will be much noisier during spin cycles if the transport bolts are not removed before use. Be sure to remove all 4 transport bolts completely before first use. Keep the transport bolts. If a pedestal was purchased with the washer, it must be installed first, prior to removing the transport bolts. Please consult the pedestal installation instructions. ▯ In order to prevent transport damage during later transport, be sure to re-install the bolts before transport. NOTICE: Keep the assemblies together and store them for later use such as when moving the washer. 1. Remove hoses from the brackets. Water connections 2. Loosen and remove all 4 transport bolts. Remove the sleeves. Take the power cable out of the brackets. 3. Place covers over the transport bolt holes Four plastic covers are provided in the small parts bag included with your washer. Separate these covers and install one in each hole where the transport bolts were removed. Lock covers firmly by pressing on the snap hook. Insert hose holder. Secure hoses in the hose holders. Water supply hose connections NOTICES ▯ The washing machine must only be operated with cold and hot (max. 140 °F/60 °C) tap water. Do not connect the appliance to the mixer tap of a pressurized hot-water boiler. ▯ To prevent water damage, the hot and cold water valves should be accessible when the washing machine is in place and should always be turned off when the washing machine is not in use. ▯ If installing the washing machine in a new building or a building in which the plumbing system was recently installed or upgraded, flush the lines before installing the washing machine to remove any sand, dirt or residue. ▯ To prevent leakage or water damage, follow the instruction in this chapter. ▯ If in doubt, have the appliance connected by a technican. Connect your washer to the wall faucets using the included AquaSecure water supply hose. Observe each of the following: ▯ Only use the new water supply hose shipped with your washer. Never connect old used hoses. ▯ The water supply hoses must not be kinked, bent or flattened in such a way as to potentially diminish water flow. ▯ The water supply pressure must be between 14,5 to 145 psi (1 - 10 bar) with a minimum of 2.2 U.S. gallons (8 liters) of flow per minute. A pressure regulator valve must be installed if the maximum water pressure is exceeded. 12