Bosch WAS20160UC Installation Instructions - Page 2

Alignment Strong odor, vibrations and "walking" can be the result of incorrect alignment! Align washing machine with a level 1. Loosen counter nut with wrench counterclockwise. 2. Change height by turning the machine feet. All four machine feet must stand firmly on the floor. The washing machine must not rock! Check alignment of the washing machine with level and correct if necessary. 3. Tighten the counter nut against the housing. - Hold the feet while doing this and do not change the height. The counter nuts of all four machine feet must be screwed tightly against the housing! Technical specifications Dimensions (width x depth x height) Weight Power supply Water pressure 23.6 x 23.2 x 33.2 in. 169.8 lbs. Nominal voltage: 220Ć240 V, 60 Hz Nominal current: 15 A 14.5 to 145 p.s.i. (1Ć10 bar) Electrical connection F F F F F This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electrical shock by providing a path of least resistance for the electric current. This appliance features a cord with an equipmentĆgrounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet which has been properly installed and grounded in accordance with all local regulations and ordinances. Improper connection of the equipment grounding conductor may result in electric shock. Have the appliance checked by a qualified electrician or service technician if you are in doubt as to whether the washer has been properly grounded. Do not modify the plug provided with the appliance - if it will not fit in the outlet, have a proper outlet installed by a qualified electrician. The washing machine must only be connected to an individual branch circuit via a socket which has been properly installed and grounded. The household electrical voltage must correspond to the voltage specifications on the washing machine. Connection specifications as well as the required fuses are stipulated on the appliance rating plate. Volts Hertz Amperes 220 Ć 240 60 15 F F Make sure that: - the power plug fits into the socket. - the wire size is sufficient. - the grounding system is properly installed. The power cord may be replaced by an electrician only. Replacement power cords are available from Customer Service. To reduce the risk of fire or electrical shock, DO NOT use an extension cord or an adapter to connect the washing machine to the power supply. If a ground fault circuit breaker is to be used, only use types marked with the following symbol: 7. Only this symbol can guarantee compliance with all current regulations. F Electrical plug: - do not insert/pull out of the socket with damp hands. - do not pull the plug out of the socket by tugging the power cord. - never pull out the plug while the appliance is operating. Transporting, e.g. when moving 1. Before transporting the machine: 1. Close water taps. 2. Release water pressure in the supply hoses. -> Operating instructions; Screen in water supply 3. Drain remaining sudsy water. -> Operating instructions; Suds discharge pump 4. Disconnect washing machine from power supply. 5. Remove hoses. 2. Install shipping locks: 1. Remove covers. 2. Replace all 4 sleeves. 3. Install all 4 shipping lock screws and tighten. To prevent unused detergent from flowing into the outlet during the next wash: Pour 1 liter of water into dispenser II and start Drain cycle. Manufacturer (see Operating instructions): 9000 280 824 5 6 7 Washing machine en Installation instructions Contents Page J Safety instructions 1 J Scope of delivery 1 J Installation surface 2 J Hose and cable lengths 2 J UnderĆcounter and inĆcabinet installation . . . 2 J Removing shipping locks 3 J Water connection 4 J Alignment 5 J Technical specifications 5 J Electrical connection 6 J Transporting, e.g. when moving 7 First operate the washing machine after reading these instructions! Also follow the separate operating instructions. Save all the documents for later use or for subsequent owner.