Bosch WFL2090UC Operating, Care, Installation - Page 25

Fault Possible cause Action Foam coming out of the detergent Too much detergent. dispenser. Mix 1 tablespoon of fabric softener with ½ litre / 1 pt of water and pour into chamber I of the detergent dispenser.Use detergent recommended for high efficiency and frontĆloading washers. Reduce the amount of detergent next time. The laundry was not spun Large items of clothing became entangled and Always load large and small items together could not be distributed evenly in the drum. into the drum. For safety reasons, the highĆspeed final spin cycle was automatically cancelled. Spin result unsatisfactory. Low spin speed selected Select higher spin speed. Repeated spinning at short intervals. This is not a fault. The imbalance compensation system is attempting to balance the load through repeated spins. The program takes longer than usual. This is not a fault. Unbalanced load detection system attempts to distribute the washing evenly by spinning it several times. Always load large and small items together into the drum. The foam detection feature has activated an Add a more appropriate amount of detergent additional rinsing cycle to reduce the amount next time. of foam. Unsatisfactory washing result. The degree of dirt was higher than supposed. Select a more suitable program. Not enough detergent. Add detergent according to the manufacturer's specifications. Detergent residue on the laundry. Some phosphateĆfree detergents contain waterĆinsoluble residues that may appear as light spots on the laundry. Brush off spots when laundry is dry. Grey residues on the laundry. Dirt accumulation from ointments, fats or oils. Add the maximum amount of detergent and select the highest permissible temperature next time. 25