Bosch WTE86300US Operating, Care, Installation - Page 19
Cleaning, moisture, sensor, bearing, shield, Changing, the light
UPC - 825225845812
View all Bosch WTE86300US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Cleaning the moisture sensor Occasionally the moisture sensor has to be cleaned because a fine layer of transparent buildup is deposited on the sensors. 7. Clean the air cooler completely, drain thoroughly. 8. Clean the seals. Changing the light bulb The dryer light turns on inside the drum when you open the door. To change the light bulb: 1. Turn off the circuit breaker. 2. Pull out power supply plug. 3. Open the door and locate the light bulb on the upper center of the seal. 9. ReĆinsert the air cooler, handle at the bottom! 10. Unscrew both locking levers. 11. Close the maintenance flap until it locks into position. This deposit can easily be removed by wiping the sensors (the two bars next to the lint filter) with a cloth and a little white vinegar. Use white vinegar only! Clean the moisture sensor once a month. Cleaning the bearing shield Over time, fluff from the drying process collects in the bearing shield. 4. Loosen the screw of the cover and open the cover. 5. Turn bulb counterclockwise. Replace the bulb with a new appliance bulb only (obtainable through customer service). 6. Replace the cover and secure with the screw. 7. Plug in dryer or reconnect power supply. This fluff can be easily removed using your vacuum cleaner, at least once a month. 19