Bose 10.2 Series II Owner's guide - Page 8

blli Ill! I III be tI I li lil tut it IIII I IF I „, 1,1 i!, dl ai r 4II 1- IFlll PI ' IIII It hit Ill III ti ito ;it up iFort's I ta, B. If both speakers sound defective. use thesame wiring to connect them to another receiver/amp known to be working properly. If the speakers now operate correctly, the problem is not in the speakers or wiring. C. Check all user-accessible fuses. Replace any fuses that appear to be blown. If the fuses blow again, have the receiver/amp checked by qualified personnel. D. If trouble persists in one or both speakers, contact your authorized Bose0 dealer. He will verify any defects andarrange for service by anauthe rized service agency or by the Bose factory. Bose Corporation will make every effort toremedy any problem within the terms of the warranty at minimum inconvenience to you. VI. Technical Information Features Direct/Reflecting° system design Acoustimass3 speaker technology Stereo Targeting° array Tweeter protection circuit Syncomo computer quality assurance program Driver Complement Two(2) 2" magnetic fluid-cooled tweeters One(1)8" midrange driver One(1)8" high power woofer inan Acoustimass° enclosure Cabinet Acoustimass° speaker design, genuine hardwood veneer or laminate over particle board finish Dimensions 383A"H (98.4 cm) x 113A"W (30 cm) x 113,4"D (30 cm) Weight 46 lb(21kg) Nominal Impedance 8 ohms(EIA standard) Amplifier Power Requirements Minimum: 10 watts per channel Maximum: 180 watts per channel 'tilt-lilt° ill II 1. - il Ir