Bowflex Xtreme 2 Assembly Manual - Page 21
Step 21: Install the Leg Extension, Step 22: Install the Leg Extension Rollers
View all Bowflex Xtreme 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
19 Step 21: Install the Leg Extension Locate the following items: Figure 21 • Item #18 - Lock Knob • Item #19 - Leg Extension Assembly 18 17 Remove the Seat (installed in Step 10), and turn it cushion side down. Insert the Leg Extension Assembly (Item #19) into the open end of the Seat Backbone (Item #17). Line up one of the holes from the Leg Extension with the hole in the Backbone, and screw the Lock Knob (Item #18) 19 into the hole on the Seat Backbone, as shown in Figure 21. Re-attach the Seat to the Seat Backbone (see Step 10). Note: You may adjust the Seat for your height once the Xtreme²™ has been fully assembled. Step 22: Install the Leg Extension Rollers Locate the following items: • Item #20 - (2) Chrome Roller Tubes • Item #21 - (4) Foam Rollers • Item #22 - (4) Foam Roller End Caps Insert the Chrome Roller Tubes (Item #20) through the upper hole and one of the lower holes of the Leg Extension (Item #19), as shown in Figure 22. Select the correct lower hole for your height - the Roller should rest on your lower shin. Slide the Foam Rollers (Item #21) onto the ends of both Tubes, then secure each Roller with an End Cap (Item #22). Note: You may need to use a Rubber Mallet to fully insert the End Caps into the Tube ends. Figure 22 21 22 20 19