Brother International 2170W Users Manual - English - Page 61
Service call indications, Main PCB failure, Fuser unit, failure, Laser unit failure, Main motor - drum light
UPC - 012502619468
View all Brother International 2170W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Control Panel Service call indications 4 If there is an error that cannot be cleared by the user, the printer will show that a service call is needed by lighting up all the LEDs as shown below. 4 If you see the service call indication shown above, turn off the power switch, and then turn it back on and try to print again. If the error remains after switching the printer back on, press the Go button and make a note of the LED's that remain lit and report the error status (as shown in the table below) to your dealer or Brother Customer Service. LED indications while pressing the Go button LEDs Toner Main PCB failure Fuser unit failure 1 Laser unit failure Main motor failure High voltage failure Drum Error Ready 1 If this error occurs, turn off the printer power switch, wait a few seconds, and then turn it on again. Leave the printer for 10 minutes with the power on. If the error occurs again, call your dealer or Brother Customer Service. 53