Brother International BAS-342G PS Basic Instruction Manual - English - Page 27
PREPARATION BEFORE SEWING, 5-1. Installing the needle, 5-2. Operating the 2-pedal foot switch
View all Brother International BAS-342G PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
5. PREPARATION BEFORE SEWING 5. PREPARATION BEFORE SEWING 5-1. Installing the needle CAUTION Turn off the power switch before installing the needle. If the foot switch is depressed by mistake, the sewing machine might start operating and injury could result. 2754B Front Front 1. Loosen the set screw (1). 2. Insert the needle (2) as far as it will go with the hollow (3) facing to the front, and then securely tighten the set screw (1). [Figure A] 1. Loosen the set screw (1). 2. Insert the needle (2) as far as it will go so with the hollow (3) facing to the front and so that it's angle matches the angle of reference line (4), and then securely tighten the set screw (1). [Figure B] * If the installation angle of the needle has been changed, be sure to readjust the needle clearance. (Refer to "11-6. Adjusting the needle clearance" in the instruction manual CD.) 5-2. Operating the 2-pedal foot switch Work clamp switch Start switch 3991M When the work clamp switch (left side) is depressed, the intermittent presser foot (1) and the work clamp (2) are lowered, and when the start switch (right side) is then depressed, the sewing machine starts operating. * The work clamp (2) lowering method can be changed using memory switch No. 002. (Refer to "7-3. List of memory switch settings" in the instruction manual CD.) 2755B BAS-342G PS 19