Brother International BE-1201B-AC Power Supply Replacement - English - Page 2

Unplugging all wire connector harnesses. P1, P2, P3, P4, P5, and P6.

Page 2 highlights

4. Unplugging all wire connector harnesses. P1, P2, P3, P4, P5, and P6. 5. Unplug all connectores to remove board. However, keep in mind that connectors only go in one spot and can not be confused. 6. Board is held inplace by plastic clip locks. In order to unlock you will need to squeese locks and lightly pull-up on board to release. (Fig. 1-1) Four-clip locks hold board down. plastic clip locks plastic clip locks 2

  • 1
  • 2
  • 3

2
4. Unplugging all wire connector harnesses. P1, P2, P3, P4, P5, and P6.
5. Unplug all connectores to remove board. However, keep in mind that connectors only
go in one spot and can not be confused.
6. Board is held inplace by plastic clip locks. In order to unlock you will need to squeese
locks and lightly pull-up on board to release.
(Fig. 1-1)
Four-clip locks
hold board down
.
plastic clip locks
plastic clip locks