Brother International BE-1204C Rotary Hook Support Bar - English - Page 2

Middle thread guide Remove Loosen Remove Technical Reference 6. Pull the needle down, by the thread guide above the needle, until it locks into place. Align the tip of the rotary hook bar behind the needle. Rotary Hook Support Bar Tip Remove 7. Position tip of rotary hook stopper so that a gap of approximately 1 - 1.5mm is maintained from rotary hook bobbin basket as indicated by the red arrow and tighten screws. 8. Turn pulley backwards, opposite of arrow, from 200 to 100 degrees (stop position). 9. Turn machine on and the needle will pop back up. 2