Brother International BE-1204C Stand Alone Type Instruction Manual - English - Page 169
I/O CPU communication, Spindle CPU error
View all Brother International BE-1204C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 169 highlights
Chapter 9 Error code list Code Error Messages E-49 Can not identify the machine model Error Can not identify the machine model Measures Turn OFF the power, check if the model identification harness is connected properly, and turn ON the power again. E-4A I/O CPU communication Failed in the communication with error I/O CPU Press the or turn ON the F/B switch on the head to either side. If the same error occurs again, the connector of communication cable on the I/O PCB may be disconnected. E-A1 E-A2 E-A3 E-A4 E-A5 E-A6 E-A7 E-A8 E-A9 E-B0 E-B1 E-B2 E-B3 E-B4 E-B5 E-B6 E-B7 E-B8 E-B9 E-BA E-BC Main (Z) motor lock Main (Z) PCB temperature is too high Main (Z) motor voltage is too low Main (Z) motor voltage is too high Spindle CPU error ERROR A6 ERROR A7 ERROR A8 Spindle CPU parameter error Lower shaft CPU error Thread jammed in rotary hook Hook motor origin point error Hook motor standby position error Hook motor standby position error Hook motor communication error Hook motor parameter error Hook motor overheat error Hook motor overcurrent error Turn off the power Thread trimming motor origin point error Power supply frequency error No power error Spindle motor lock Main PC board temperature too high Spindle motor voltage too low Spindle motor voltage too high Spindle motor CPU error Spindle motor CPU communication command error Spindle motor CPU send/receive error Spindle stop position signal error Spindle CPU parameter error Lower shaft CPU error Thread tangle in rotary hook Hook motor origin point error Hook motor standby position error Hook motor motor mode error Hook motor communication error Hook motor parameter error Hook motor overheat error Hook motor overcurrent error Thread trimming motor zero point error Power supply frequency error No power error Press the or turn on the F/B switch on the head to either side. If it occurs frequently, the main shaft mechanism is faulty. This is not usually displayed. Adjust the pulley stop position (100 °) above the needle and press the . If the error occurs frequently, the parts related to the main shaft stop position sensor are faulty. This is not displayed in this model. Turn the power off and on once. If the same error occurs again, the lower shaft motor is faulty. Turn the power off and check the thread trimmer and turn the power on again. If it occurs again, the thread trimmer is faulty. It may usually occur momentarily when turning off the machine. If it occurs when the machine is on, it is a power failure detection error. BE-1204B-BC • BE-1206B-BC 9-5