Brother International CE-5000 Operation Manual - Page 30
Starting to sew
View all Brother International CE-5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
SEWING BASICS Starting to sew Lower the presser foot lever. e Raise the needle by turning the handwheel a toward you (counterclockwise) so that the mark on the wheel points up. (With models equipped with (needle position button), raise the needle by pressing once or twice.) a Presser foot lever On models equipped with a sewing speed or f controller, slide the sewing speed controller to the left or right to adjust the sewing speed. Refer to "Sewing speed controller" (page 10). a Mark b Needle position button Raise the presser foot lever. b a Presser foot lever Place the fabric under the presser foot, pass c the thread under the presser foot, and then pull out about 5 cm (2 inch) of thread toward the rear of the machine. a Sewing speed controller Slowly press down on the foot controller. g (With models equipped with (start/stop button), if the foot controller is not connected, press once.) or a 5 cm (2 inch) While holding the end of the thread and the d fabric with your left hand, turn the handwheel toward you (counterclockwise) with your right hand to lower the needle to the starting point of the stitching. a Start/stop button X The machine starts sewing. Take your foot off the foot controller, or press h (start/stop button) once (if the machine was started by pressing (start/stop button)) (for models equipped with the start/stop button). X The machine stops sewing. Raise the needle by turning the handwheel i toward you (counterclockwise) so that the mark on the wheel points up. (With models equipped with (needle position button), raise the needle by pressing once or twice.) Raise the presser foot lever. j 28