Brother International CS-100T/4000 Operation Manual - Page 17
For models equipped with the quick-set bobbin
View all Brother International CS-100T/4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
the right side (see arrow b) until the cover clicks into place. • Replace the cover so that the end of the thread comes out from the left side of the cover (as shown by the line in the diagram). ■ For models equipped with the quick-set bobbin Raise the needle to its highest position by turning a the handwheel toward you (counterclockwise) or press (needle position button) (for models equipped with the needle position button), and raise the presser foot lever. Slide the button and open the cover. b 1 2 • Make sure that the thread is correctly inserted through the tension-adjusting spring of the bobbin case. If it is not inserted, reinsert the thread. 1 1 a Tension-adjusting spring Memo ● The order that the bobbin thread should be passed through the bobbin case is indicated by marks around the bobbin case. Be sure to thread the machine as indicated. a Cover b Slide button Put the bobbin in, feed the end of the thread c through the slit, and then pull the thread to cut it. Replace the bobbin cover. Put the left tab in d place (see arrow a), and then press lightly on the right side (see arrow b) until the cover clicks into place. • Only use bobbins that were designed to be used with this machine. CAUTION ● Make sure you set the bobbin so the thread unrolls in the right direction. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or break the needle. 1 a Cutter Memo ● You can begin sewing immediately without drawing up the bobbin thread. If you want to draw up the bobbin thread before you start to sew, follow to the procedure in "Drawing up the lower thread" (page 19). 15