Brother International Innov-is 2800D Users Manual - English - Page 202
threading is done, the machine will not operate properly. Also, depending on the pattern selected,
View all Brother International Innov-is 2800D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 202 highlights
TROUBLESHOOTING Problem Needle breaks Cause The needle is installed incorrectly. The needle clamp screw is not tightened. The needle is bent or blunt. The thread or needle is not suitable for the type of fabric being sewn. The wrong presser foot was used. The upper thread tension is too strong. The fabric is pulled during sewing. The spool is installed incorrectly. There are scratches around the hole in the needle plate. There are scratches around the hole(s) in the presser foot. There are scratches on the race (bobbin case). The fabric does not feed through the machine The needle is defective. The feed dogs are lowered. The stitches are too close together. The wrong presser foot was used. The needle is bent or blunt. The thread is tangled. The machine does not operate There is no pattern selected. The "Start/Stop" button was not pressed. The main power switch is not turned on. The presser foot is not lowered. The "Start/Stop" button was pressed while the foot controller is connected. The foot controller was pressed to begin embroidering. The embroidery unit does There is no pattern selected. not operate The main power switch is not turned on. The embroidery unit is not attached correctly. The embroidery frame was attached before the unit was initialized. The LCD display is difficult The LCD contrast is not properly adjusted. to see Solution Reinstall the needle correctly. Tighten the needle clamp screw. Replace the needle with a new one. Check the table of fabric, thread and needle combinations, and select the appropriate combination. Attach the correct presser foot. Adjust the thread tension. Do not pull the fabric during sewing. Reinstall the spool correctly. Replace the needle plate, or consult your authorized dealer. Replace the presser foot, or consult your authorized dealer. Replace the race (bobbin case), or consult your authorized dealer. Replace the needle. Use the feed dog position switch to raise the feed dogs. Lengthen the stitch length. Attach the correct presser foot. Replace the needle with a new one. Use scissors, etc., to cut the tangled thread and remove it from the race (bobbin case), etc. Select a pattern. Press the "Start/Stop" button. Turn the main power to on. Lower the presser foot. Remove the foot controller, or use the foot controller to operate the machine. Remove the foot controller and use the "Start/ Stop" button to operate the machine. Select a pattern. Turn the main power to on. Reattach the embroidery unit correctly. Perform the initialization process correctly. Adjust the LCD contrast. Page 35 36 35 37 211 45 − 29 − − − 35 86 44 211 35 − 50, 94, 124, 167 40 16 40 11, 41 11 50, 94, 124, 167 16 122 123 21, 196 CAUTION • This machine is equipped with a thread detection device. If the "Start/Stop" button is pushed before the upper threading is done, the machine will not operate properly. Also, depending on the pattern selected, the machine may feed the fabric even if the needle is raised. This is due to the needle bar release mechanism. At these times, the machine will make a sound different from that made during normal sewing. This is not the sign of a malfunction. • If the power is disconnected during sewing: Turn the main power to OFF and unplug the machine. If you restart the machine, follow the instructions for operating the machine correctly. 200