Brother International JX3135F Operation Manual - Page 15
Pass the end of the thread through the hole
View all Brother International JX3135F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Pass the end of the thread through the hole Trim the excess thread above the bobbin. 3 on the bobbin from the inside of the bobbin. 7 • Leave 1 cm (1/2 inch) of thread from the hole on the bobbin. 1 Put the bobbin onto the bobbin winder 4 shaft and slide the bobbin winder shaft to the right. Turn the bobbin clockwise, by hand, until the projection slides into the notch of the bobbin. • Make sure to pull out 7 to 10 cm (3-4 inches) of thread from the hole on the bobbin. 3 1 2 1 1 1 cm (1/2 inch) CAUTION ● Make sure you follow the instructions carefully. If you do not cut the excess thread completely before winding the bobbin, when the thread runs low it may tangle around the bobbin and cause the needle to break. Press the foot controller to start. 8 1 Projection 2 Notch 3 7-10 cm (3 - 4 inches) CAUTION ● Pull the thread taut and hold the end of the thread straight up. If the thread is too short, not pulled taut or held at an angle, injuries may occur when the thread is wound around the bobbin. Turn on the machine. 5 CAUTION ● Do not turn on the machine while pressing down the foot controller. The machine may start unexpectedly and cause personal injury or damage to the machine. While holding the end of the thread, 6 gently press the foot controller to wind the thread around the bobbin a few times. Then stop the machine. When the bobbin seems full and begins 9 spinning slowly, take your foot off the foot controller. Cut the thread, slide the bobbin winder 0 shaft to the left and remove the bobbin. Note ● When the sewing machine is started or the handwheel is turned after winding the thread around the bobbin, the machine will make a clicking sound; this is not a malfunction. ● The needle bar does not move when you slide the bobbin winder shaft to the right. CAUTION ● Not winding the bobbin properly may cause the thread tension to loosen, and may break the needle. 1 2 1 Wound evenly 2 Wound poorly 14