Brother International KE-484C Instruction Manual - English - Page 44
Adjusting the work clamp lift amount, STANDARD ADJUSTMENTS
View all Brother International KE-484C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
10. STANDARD ADJUSTMENTS 10-5-2. Adjusting the engagement of the movable knife and fixed knife Fig. 1 Movable knife 0149Q Cutting edge Cutting edge Fixed knife 3211Q A. After the movable knife and fixed knife are properly engaged, tighten the screw as shown in Fig. 1. B. Turn the movable knife (in the direction of the arrow) while the screw is still tightened. C. Loosen the screw. D. Turn the movable knife (in the direction of the arrow) while the screw is still loosened. Repeat above steps A , B, C and D four or five times to maintain the cutting performance of the knife. 10-6. Adjusting the work clamp lift amount The maximum work clamp lift amount is 25 mm from the top of the needle plate. The lift amount is adjusted 17 mm at the time of shipment. Cutting edge Cutting edge 3213Q 25 mm max. 2618Q 1. Raise the work clamp (1) and loosen the screws (2). 2. Adjust the work clamp lift by moving the presser levers (3) and (4) up and down and then tighten the screws (2). * If movement is sluggish when the work clamp (1) is being raised and lowered, it may not be possible to increase the work clamp (1) lift amount. Apply grease to the sliding part of the work clamp (1) (grease is already applied at the time of shipment), and check that the movement becomes easier. KE-484C 38