Brother International LB-6800 Operation Manual - Page 29
Installing the bobbin
View all Brother International LB-6800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Cut the thread with scissors beside the bobbinb winding thread guide. Installing the bobbin Install the bobbin wound with thread. a CAUTION 1 ● Use a bobbin that has been correctly wound with thread, otherwise the needle may break or the thread tension will be incorrect. a Bobbin-winding thread guide Slide the bobbin winder shaft to the left, and c then remove the bobbin from the shaft. Hold the thread end with your left hand, and d wind off the thread clockwise near the bobbin with your right hand as shown below. ● The included bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB (XA5539-151)). Actual size 11.5 mm (7/16 inch) This model Other model Memo z The order that the bobbin thread should be passed through the bobbin case is indicated by marks that surround the bobbin case. Wind the bobbin again. e Note z Make sure that the thread passes under the pretension disk of the bobbin-winding thread guide correctly (page 24). Winding/Installing the Bobbin 27