Brother International LS2400 Operation Manual - Page 12
Lower threading - needle
View all Brother International LS2400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
KNOWING YOUR SEWING MACHINE While holding the end of the thread, gently press f the foot controller to wind the thread around the bobbin a few times. Then stop the machine. Memo ● When the sewing machine is started or the handwheel is turned after winding the thread around the bobbin, the machine will make a clicking sound; this is not a malfunction. ● The needle bar does not move when you slide the bobbin winding shaft to the right. a 7-10 cm (3-4 inches) Trim the excess thread above the bobbin. g • Leave 1 cm (1/2 inch) of thread from the hole on the bobbin. CAUTION ● Winding the bobbin improperly may cause the thread tension to loosen, breaking the needle and resulting in injury. a 1 cm (1/2 inch) CAUTION ● Make sure you follow the instructions carefully. If you do not cut the thread completely, and the bobbin is wound, when the thread runs low it may tangle around the bobbin and cause the needle to break. Press the foot controller to start. h When the bobbin seems full and begins i spinning slowly, take your foot off the foot controller. Cut the thread, slide the bobbin winder shaft j to the left and remove the bobbin. 1 2 a Wound evenly b Wound poorly Lower threading Install the bobbin wound with thread. CAUTION ● Make sure you turn the power off while threading the machine. If you accidentally step on the foot controller and the machine starts to sew, you could be injured. ● -" Moving parts - To reduce the risk of injury. Disconnect from supply circuit before servicing. Remove cover." Raise the needle to its highest position by turning a the handwheel toward you (counterclockwise) and raise the presser foot lever. 11